Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - vortec head modification for .480 lift
View Single Post
  #34 (permalink)  
Old 09-30-2011, 01:01 PM
spinn's Avatar
spinn spinn is offline
Registered User

Last journal entry: This makes a huge difference
Last photo:
Join Date: Oct 2004
Location: here
Posts: 2,553
Wiki Edits: 0

Thanks: 14
Thanked 88 Times in 85 Posts
Run hard, whats that. It is drivin . The vehicle takes my scooters out by my brothers' kids for a blast. That is about 100 miles round trip. It does burnouts and the wide open downshifts that kick nice. Using a phone device with GPS an app for testng performance, claimed sub 16 quarter at 88 mph. To take it to a track is big money, and all the test and tune days are gone. Byron, Rt 66 ,and great lakes are busy, and have no time for my messing around. For the admit you might get 2-3 runs. This has been together many months.

The keeper/locks are stock from the vortec 906 heads. If someone works at a yard or parts depot, measure the v6 series 2 valves, that will tell if it is really 8mm or 11/32 .

GM advertised spring rate of 330-365lb/in depending on the .

Is sinking the spring seat the good way?

Did not mean to steal the thread.
Attached Thumbnails
Click image for larger version

Name:	trck30510.jpg
Views:	218
Size:	43.0 KB
ID:	58707  

Last edited by spinn; 09-30-2011 at 01:08 PM.
Reply With Quote