Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Welding MIG? Flux Core? ARC?
View Single Post
  #1 (permalink)  
Old 04-26-2004, 12:44 PM
70chevy's Avatar
70chevy 70chevy is offline
Eager and Willing to Learn
 
Last photo:
Join Date: Feb 2004
Location: Greenville TX
Age: 28
Posts: 251
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Welding MIG? Flux Core? ARC?

I know that mig is the way to go as far as ease of use and not warping etc, but it just makes me sick to my stomach to think i have to spend 450 at least to get a crappy setup, When welding on my patch panels can it be done with a small flux core wire in a wire feed welder? What about a small arc (stick as I know them) welder? I want to be assured the welds will hold I dont necessarily care if i have to do more body work fixing warps and things of that nature, i would rather spend ten bucks on a gallon of bondo than and a week fixing things than $450 on a welder!! Any thoughts?
Reply With Quote