Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Welding MIG? Flux Core? ARC?
View Single Post
  #6 (permalink)  
Old 04-26-2004, 11:18 PM
tresi tresi is offline
Member
 
Join Date: Apr 2004
Location: Cassville,MO
Posts: 821
Wiki Edits: 0

Thanks: 21
Thanked 45 Times in 41 Posts
Gas welding warp it like a wash board. Arc will blow hole right through it. Before I had a MIG set up I did it with a cheap 115 volt flux core welder. It can be done but you'll want to get a wire brush to fit in a 4" grinder and clean it very well. It won't leave as much flux as an arc welder but it still will be need to be removed completely.
Reply With Quote