Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Wet sleeve in a SBC:
View Single Post
  #4 (permalink)  
Old 10-03-2012, 10:01 PM
against all odds against all odds is offline
Banned User
 
Last photo:
Join Date: May 2011
Location: N.E.
Posts: 385
Wiki Edits: 0

Thanks: 9
Thanked 6 Times in 6 Posts
So, here is what we are dealing with:







If the whole cylinder wall has to be machined away, then the only points of rigidity for the sleeve not to move around would be at the deck. As i said earlier, this block would only be used for transportation. Smokey said that wet sleeving a small block chevy is not a good idea but he may have meant for racing.
Reply With Quote