Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - The "What Did You Work On Today" thread
View Single Post
  #3530 (permalink)  
Old 05-17-2013, 07:34 PM
1971BB427's Avatar
1971BB427 1971BB427 is offline
Registered User
 

Last journal entry: Latest changes
Last photo:
Join Date: Dec 2010
Location: Portland
Posts: 1,659
Wiki Edits: 0

Thanks: 14
Thanked 272 Times in 237 Posts
Quote:
Originally Posted by 496CHEVY3100 View Post
It should have fit without any mods at all ,this is a 63 Chevy in the shop with a Radical 427 BBC ,Muncie M22 4 speed it was a direct bolt in with 69 Chevlle Standard BBC mounts ,if you use SBC the engine sits to far to the rear..
Do you mean BBC frame monuts, or motor mounts? The motor mounts on a SBC and BBC siit in the same position, but BBC motor mounts are taller than SBC motor mounts. The frame mounts are different, but not sure in what way.
I could never run tall valve covers on the 427 in my Camaro, as they just wouldn't clear the heater outlets, and the brake booster. I even ran SBC motor mounts to drop it down, and still not enough clearance.
Reply With Quote