[adantessr]

Originally Posted by 123pugsy

I got my head light plate holding jig made up so I can fit the new headlight plates true to each other and square.

Do I remember correctly that you are planning to use V dub headlights ?

[123pugsy]

Originally Posted by adantessr

Do I remember correctly that you are planning to use V dub headlights ?

That was DBM on his 48.

I'm using 37 Ford.

[MARTINSR]

Originally Posted by 123pugsy

Thanks Brian.

I have a long weekend to try and get the two plates fitted in and welded.

I'd like to get at least one done properly this weekend. I've got to take my time as everything I've done quickly has come back to bite me.

Making templates and patterns is ALWAYS very good time spent. The time spent on that jig will save so much on the work, you won't even have to think about it as you are doing the fenders, it's right there, beautiful.

Brian

[123pugsy]

Originally Posted by MARTINSR

Making templates and patterns is ALWAYS very good time spent. The time spent on that jig will save so much on the work, you won't even have to think about it as you are doing the fenders, it's right there, beautiful.

Brian

Yep. It already showed me the fenders are not ready to accept the new plates yet.

Been out in the garage tap, tap, tapping,,, shrink, shrink, shrinking.....

[MARTINSR]

I went ahead and pulled the motor/pump out and disassembled it. The shaft on the motor did have some pitting, I ran it in a drill and sanded it down to smooth it out some. Checked everything and put it back in. On the first test I see nothing but I didn't see anything before it sat a day or so anyway, we will see.


Brian

[John long]

My fingers are crossed Brian......

[monster76]

R&r clutch fly wheel on an international 4700. But my own projects seem to be located in no time for nothing land

[Chevrolet4x4s]

93 Silverado
Shane

[adantessr]

I installed a couple of performance chips in my '98 C-1500, hoping for some gains for pulling my 25 ft 5th wheel camper. Then I bled the heater core. Getting warmer air now but not what I need. Gonna have to flush with acid. Any recommendations on what to use are appreciated. Thanks, Big Al

[Project89]

trans swap and cam swap at the same time in my twin turbo camaro.started this yesterday and went back at it at 4am today and just got finished a few hours ago
needs some more tuning but my laptop died on me ( forgot to plug it in )

[John long]

Really cleaned up the shop/basement today. I need to find an excuse to mess it up again but for now a cold beer in the swing and one of Sid Chavers videos is a neat way to spend a couple of hours.

John L

[MARTINSR]

That is just too damn organized you are a sick man.

Brian

[John long]

The last cruise is oct 26th. I am going to pull the doors and repaint them and the top of the cowl afterwards. Will have it a mess before you know it.

[MARTINSR]

Originally Posted by Project89

trans swap and cam swap at the same time in my twin turbo camaro.started this yesterday and went back at it at 4am today and just got finished a few hours ago
needs some more tuning but my laptop died on me ( forgot to plug it in )

I love twin turbos, very cool!

Brian

[MARTINSR]

Originally Posted by John long

The last cruise is oct 26th. I am going to pull the doors and repaint them and the top of the cowl afterwards. Will have it a mess before you know it.

You better, it's making most of us look bad! I get all organized and looking good......it stays that way for about a week.

Brian