Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - What do you think of my proposed setup?
View Single Post
  #2 (permalink)  
Old 06-29-2010, 04:09 PM
Custom10's Avatar
Custom10 Custom10 is offline
my KARMA ran over my DOGMA
 

Last journal entry: SS
Last photo:
Join Date: May 2009
Location: Saskatchewan, Canada
Age: 49
Posts: 1,099
Wiki Edits: 0

Thanks: 18
Thanked 29 Times in 25 Posts
Just one thing to add here as I will leave the build instructions to the experts. Shooting for 9.5 SCR with 64 CC heads will require a dished piston, if you are so inclined look at the KB hypers that I used on my 383 at -18 cc that should get you close with around 0.040 squish. Going with these slugs will require close attention to the ring gap settings and get them in there tight at no more than 0.002 piston to wall clearance. My 2cents

PS welcome to HotRodders...don't worry you will get some expert input here for sure, some friendly advice...careful not to bash other forums or folks you never know who's listening
Reply With Quote