Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - where to cut quarter panel?
View Single Post
  #7 (permalink)  
Old 09-28-2010, 01:44 PM
nanaimoBC nanaimoBC is offline
Registered User
 
Last photo:
Join Date: Sep 2010
Location: nanaimo BC canada
Posts: 17
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
He wants the full qtr with door jamb that welds to the inner pinch weld...the convert one only has the lip that welds to the jamb...is my understanding.I would think you could use the full qrtr and cut it just below the pich weld where the convert top sits and use the full qrtr into where the trunk rubber sits and the corner glass this should keep your filling to a minimum. Just my opinion without actually looking at it
Reply With Quote