Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - where to cut quarter panel?
View Single Post
  #12 (permalink)  
Old 09-29-2010, 02:15 PM
freethinker52 freethinker52 is offline
Registered User
 
Last photo:
Join Date: Jun 2010
Location: MIDWEST
Posts: 95
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Quote:
Originally Posted by Pontiac_Judas
I'd be very careful where you cut here. I know the listing says "coupe/convertible", but I have heard the area around the peak of the convertible (from about the wheel well up) has a very different shaped "bow" then the hardtop. They say you can "make it work", but you could make a flat sheet of cold-rolled steel work with enough effort.

I would definitely head over to performance years pontiac forum and look around because this type of question has come up there before.

Good luck!
that is exactly the kind of information i am looking for. can you direct me to the information you are talking about? i am looking on that site but dont see it.
Reply With Quote