Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - wire wheel + cast iron heads
View Single Post
  #1 (permalink)  
Old 06-03-2012, 02:58 PM
1990fordLTD 1990fordLTD is offline
Registered User
 
Last photo:
Join Date: Sep 2010
Location: Canada
Posts: 10
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
wire wheel + cast iron heads

Need to get baked-on intake (EGR port) gaskets off of small block Ford heads, still on the car or I'd take 'em to a shop and have it done in 2 minutes with an angle die grinder but all I have access to here is a drill w/ a coarse wire wheel. Can i used that to get the baked on gasket off of the heads without damaging it?

The wire wheel is brass.
Reply With Quote