Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Wood working
Thread: Wood working
View Single Post
  #9 (permalink)  
Old 09-24-2002, 05:42 AM
dave5113 dave5113 is offline
Registered User
 
Join Date: Jan 2002
Location: north WI.
Posts: 4
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Post

On the back side of the plywood from top to bottom make some cuts with a saw about 1/2" apart, but not into the last ply of the wood. Get the good side of the plywood wet, bend it to shape, when it is dry, sand off with 220 sand paper. If it will not bend, make the cuts 1/4" apart.Go slow. Hope this helps.
Reply With Quote