Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Yukon 3.75 gears for Ford 9 inch....noise
View Single Post
  #9 (permalink)  
Old 02-21-2011, 08:07 PM
96lt4c4's Avatar
96lt4c4 96lt4c4 is offline
Registered User
 
Last photo:
Join Date: Oct 2009
Location: Bardstown, KY
Age: 34
Posts: 109
Wiki Edits: 0

Thanks: 0
Thanked 0 Times in 0 Posts
Well this is where I am going to run it. I took it all back apart, started over, and put it back together in the aluminum case. I think my problem before was that I wasnt tightening the caps tight enough before check my pattern. I put it back in the car and ran it on jack stand and I didnt hear a peep out of it. Before I could hear the noise running the car on jack stands. I havent drove it yet so we shall see...

This is with .025 pinion shim and .010 back lash.



Reply With Quote