Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - $129 HF Planishing Hammer Review
View Single Post
  #25 (permalink)  
Old 12-19-2014, 08:17 PM
timothale timothale is offline
Registered User
 
Last wiki edit: General Motors transmissions
Join Date: Mar 2006
Location: near Yellowstone park
Posts: 5,476
Wiki Edits: 27

Thanks: 60
Thanked 645 Times in 542 Posts
beading dies

A few years ago I took the panel fab class, at UVU, they have a street rod, series of classes, I was over 65 and the "grandpa" cost was only $ 100 per semester, The regular students had to pay over $1100. They had a commercial planishing hammer, I don't know the brand, and an assortment of dies. You can do the beading and flanging with the right dies. The lower beading die has a tab welded to it that was held so it wouldn't rotate with a hose clamp. I used it a couple times when the pullmax was booked up . I have started building a smaller "pulmax" type machine out of a heavy cast iron frame from a carton stapling machine, you should be able to copy most of the pullmax type dies.
Reply With Quote