First you cut out your two side's,then you make the template for the center piece's.Then cut them out.These fenders are going to be for a Harley Davidson trike
This is where it take's time,The better you can make the buck,The better your mold will come out.So by taking your time here to get it nice and straight.You may have to block and prime a few times.But it will be better in the end.
Did some more blocking today.I just about have it ready for some gel coat.The better you get it at this point,the better the mold will be.And the better the part will be too.
)
)
)
)
)
)
)
)
)
)
)
)
)
)