Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans Advertise
hotrodders.com: Project Journals: Cridder's Journal
User Name
Password
lost password?   |   register now

View Cridder's profile Entries: 3
Views: 798
view from the beginning || now viewing most recent entries



11-09-2019 09:38 AM My chevy 334 build
This 334 is a 30 over Vortec 305 chev destined to replace the tried and true but tired 305 that is currently in my 88 S-10

This was going to be a 310 build but lately i've been kicking around the idea of stroking this to 334 as i have a spare 3.75 inch eagle crank on hand.
I want to keep the 5.7 inch rods and mill down a set of speed pro 534cp flat tops to complete the reciprocating part of the assembly, probably gonna mill a dish in there too.
Cam is a roller, GM factory roller that i had reground to 217 by 227 at 0.050 with .450, .460 lift LCA is 112

Head choices are TBI 187s, Vortec 059s and ZZ4 113s all 58cc chambers.
The 187 swirl-ports are ready to go and will easily out flow the other two heads so im gonna go with those till i can get the ZZ4s ported out and prepped and then ill bolt those on.

  [Entry #3]

09-08-2012 03:00 AM JEEP 4.0 stroker for my 83 CJ7
Objective: build a 4.5 liter jeep 6 by combining crank and rods from a 4.2 with the block and head from a 4.0

So far i've collected up (4) some 4.0 and 4.2 jeep engines and the plan is to mix and match parts till i get a 4.5 litre stump puller. might build several and sell a few if all go's well

Cam and lifters on hand is a lunati grind 216 @ 0.050

  [Entry #2]

09-08-2012 02:20 AM


  [Entry #1]



All times are GMT -6. The time now is 09:02 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.