Well the tail panel is wrapped up so on to the Deck Lid. The one on the car was pretty messed up so I picked up a new deck lid skin and decided to start the process of re skinning the deck lid framework.
Tear down was not all that surprizing as the old skin came of quite readily. There are some typical rust out spots. I picked up some 18ga steel to replace the rust out spots. Now all I have to do is decide where to cut and what to replace in the inner frame. So I am going to try to drop a few pictures here and maybe get some advice on where to cut and hack.
Set back and lets see what happens.
Picture 1 This is the Inner deck lid frame.
Picture 2 Backside of the panel showing damage spots.
Picture 3 Good look at the left side rust.
Picture 4 Underside view of right side.
Picture 5 Wider view of picture 4.
Picture 6 Right rear corner.