Hot Rod Forum : Hotrodders Bulletin Board - Conversation Between Irelands child and silverton_ford
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans Advertise
Hot Rod Forum : Hotrodders Bulletin Board > Irelands child
User Name
Password
lost password?   |   register now

Conversation Between Irelands child and silverton_ford
Showing Visitor Messages 1 to 2 of 2
  1. Irelands child
    01-09-2018 08:50 AM - permalink
    Irelands child
    Drian
    I apologize for taking 2 months to respond to your note to me - had some health issues that kept me away from many of my favorite sites.

    To answer your question, I do not have a specific build sheet though do have a list of most of the parts used but needs updating.

    I know that you said that you want to use a 4spd top loader - I have to tell you that you will have limited room for this and why I went with a C4. This is due to needing some engine set back, room for a reasonable foot area and the difficulty of locating a clutch pedal. My engine is back even further then most but even without that setback, would have never had enough room.

    Let me know what help I can give you - but using this for an email will ensure that I see it quicker - [email protected]

    Dave W
  2. silverton_ford
    11-07-2017 11:18 PM - permalink
    silverton_ford
    Hello. My name is Brian. I noticed that you built a 1931 Roadster with a Ford motor. Great car. I like it. I love that you stuck with a Ford engine. I am currently just getting started building my 1930 Roadster with a small block Ford and 4-speed toploader. Do you have a "build thread" that you posted about the progress of your car? I am new to this forum but frequent many others. I have searched 1930 Roadster, and haven't come up with very much. I know I am going to have a ton of questions and was hoping I could find some good information here. I realize my build may vary from others, but a lot of information should cross over a bit. Can you help me? Thank you. Brian

All times are GMT -6. The time now is 08:56 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.