Hot Rod Forum : Hotrodders Bulletin Board - View Profile: madbaker@comcast.net
Hotrodders.com -- Hot Rod Forum



Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans Advertise
Hot Rod Forum : Hotrodders Bulletin Board
User Name
Password
lost password?   |   register now

[email protected] madbaker@comcast.net is offline

Registered User

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. madbaker@comcast.net
    07-16-2019 06:52 PM - permalink
    [email protected]
    hey...any one have any ideas on how much piston expansion (reaching operating temp) affects piston rock in the cylinder?? I'm trying to decide on head gasket thickness, (quench, squish clearances) 4.600" bore. I would like a .042 ish deck clearance but i am concerned about not being able to determine how much piston rock I will have at operating temp...the piston rocks up on the quench area (12 o'clock) .007"(@TDC,cold with rings installed) the pistons are .011 out of the hole. I would like to use a .053" head gasket but not sure if this will be adequate clearance with .007 piston rock??

About Me

  • About [email protected]
    Biography
    retired
    Location
    georgia
    Interests
    pro-street
    Occupation
    ret. corrections

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 12-01-2019 12:17 PM
  • Join Date: 07-01-2019

All times are GMT -6. The time now is 03:49 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright Hotrodders.com 1999 - 2012. All Rights Reserved.