|07-07-2019 05:19 PM|
I've got an Imperial-Eastman. works well but not incredibly fancy, just a sturdier version of the old style like has been used for 45° copper tubing for 100 years.
I've heard vintage Military surplus was the cat's meow, but never seen one personally. Makes sense though.
|07-07-2019 09:49 AM|
|predator carb guru||
37* single flare tool
Ok, is anybody making their own single 37* flares in SS tubing? If so, what tool are you using to make them? I've always had my stuff done when it comes to that but decided that it's easier if I do them at home for a change. This is for nitrous lines by the way, 3/16's stuff.
Looking for all recommendations....not looking to spend the federal budget, but I want a quality tool that will last too.....