Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans Advertise
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Engine> SBC 350 erratic temperature
User Name
lost password?   |   register now

Thread: SBC 350 erratic temperature Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:


Additional Options
Miscellaneous Options

Topic Review (Newest First)
01-03-2002 07:24 PM
nwallin First check the guage for correct temps using another guage of some type for a comparison. FIx the damn leak, it will bite you sooner or later...
As for the temp changes it has factors of ignion timing, water pump, thermostat, cooling fan, the flow of the colant, engine bore, spark plugs, loose fan belts. Most small block chevys were ment to run 190 degrees and as high as 215 degrees temp. on newer cars
12-31-2001 11:41 AM
HotRodF100 I guess that I left a couple of important things out, it's not an electronic gauge, it has a capilary tube. Also, the sensor is in the manifold, not in the block. The timing is set for 8 DBTDC at idle with the advance disconnected. I was concidering moving the sensor down onto the head but never thought about the header heat. The thermostat has been changed twice. The hoses and pump I believe are new. The carb is a new Edelbrock (550 CFM I think) squarebore that I have messed with the idle mixture a little because the fumes in the garage are a little rough. The distributor is a new Mallory unit and the advance seems to work OK according to the timing light. Thanks for the good advice so far!

[ December 31, 2001: Message edited by: HotRodF100 ]

[ December 31, 2001: Message edited by: HotRodF100 ]</p>
12-30-2001 08:48 AM
fletch69 what kind of 350 pontiac or chvy? I had problems with my pontiac. lots of stuff so if you want to hear about them post me back
12-30-2001 07:20 AM
Phat As Ed says grounds are very important on electric gauges. DO NOT sister the grounds together under the dash for the temp gauge run a seperate ground for that gauge to a good ground. Also i dont like the idea of the sender in cyl head(if thats were yours is) i like it up in the intake were it belongs,with header heat not effecting your readings. Go see if a friend has a mech gauge you can use and check it against your electric. Pressure test the cooling system first and find the leak cause if you have a crack or gasket problem the temp gauge problem dont matter anyway its got to come apart.
12-29-2001 06:43 PM
edcroozer Just my 2 cents here, If it is an electonic sender, make sure you didn`t put silicone on the sender threads. The sender needs a ground to work properly. The silicone would isolate it from grounding. Then give you irratic readings.
12-29-2001 06:10 PM
Tom First off try a new guage. If the temp is actually fluctuating it could be several reasons bad thermostat, cracked head, bad head gasket,collapsing hose,stuck mech advance, incorect timing, lean mixture or bad carb, vacume leak,ect ect... but if the guage is acting funny I would start there. As for the leak get a cooling system pressure tester it will show you the leak
12-29-2001 04:56 PM
SBC 350 erratic temperature

My 350 has 3,100 miles on it since rebuild. It was fine when I bought it with 1,600 miles, this is a recent developement. So far I have replaced the thermostat, used distilled water, and put in new antifreeze. Next will be a radiator check and boil-out. I really think that I have 2 problems. My Stewart Warner temp gauge doesn't come off of the bottom peg for a couple of miles, then it jumps right to 145 and continues normal as if it is stuck or it's not sitting in water. Once it comes up to temp (180 stat), it stays at temp for about 5-10 miles. Then it goes up to about 210 and will fluctuate between 185-210. I also have a very minor leak at the back of the engine somewhere, I see a drop or 2 on the floor every once in a while. I'm not sure where water could even come from other than maybe a freeze plug behind the bell housing. Your thoughts?? Who knows, maybe the gauge is the problem with both??? Thanks

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 02:59 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.