|01-12-2012 09:14 PM|
|68NovaSS||My mistake, looking at our drawing, I was upside down in my thinking of what the arrows indicated, sorry.|
|01-12-2012 09:01 PM|
|01-12-2012 08:47 PM|
You have a nice vintage looking mill there, original dampener? You might want to consider checking for true TDC and then make a timing tape so you/we need not guess.
|01-12-2012 07:54 PM|
|Sin7||sorry for the poor quality. I had to hold the timing light with my teeth|
|01-12-2012 07:51 PM|
Thanks for the quick reply. I actually watched that video you suggested a few times. In fact that video is what actually sparked me to check mine.
I marked "off" because that's where the harmonic balancer timing mark landed the last time i shut the engine off. Here's a picture and video i just took of both idle timing and increased RPM timing that shows how the timing mark climbs way ATDC like you indicated.
As I increased RPM's
|01-12-2012 06:13 PM|
Yes each mark is 2 degrees. But in your drawing, what is "Off"? Also, your mark at idle is drawn as WAY ATDC, retarded, and at rpm, even further. I think you drew it upside down. As you rev, the timing will advance, move further from zero, BTDC. You know to time it with the vacuum advance disconnected from the distributor and plugged? Set it at about 12 deg BTDC as a starting point, then adjust it from there when it's up and running. A modified SBC likes initial timing, some as much as 16 or 18 degrees., up to about 36 total, as long as it doesn't detonate or "ping". Watch this video and see how the timing moves.
|01-12-2012 03:44 PM|
283 SBC timing tab reading... normal??
Quick question. Based on this diagram what would you say my timing is on my 283 sbc with 2 barrel carb ? As you can see, when I shoot it with a timing light the mark is past the timing tab itself so I canít tell what the timing is. Each arrow shows the location of the harmonic balancer timing mark in relation to the timing tab.
Is each mark 2 degrees? Just want to make sure the timing is within spec. Iíve noticed a slight stumble when accelerating, but disappears at about 20mphÖ Timing or carb?
Thanks in advance for any help you guys can provide. In the meantime i'll continue to search the web for answers.