Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans Advertise
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Body - Exterior> epoxy/2k over sanded BC/CC
User Name
lost password?   |   register now

Thread: epoxy/2k over sanded BC/CC Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Additional Options
Miscellaneous Options

Topic Review (Newest First)
09-19-2013 07:04 AM
deadbodyman if you had the best of both worlds you would use a buildable epoxy primer thats ez to sand...I rarely use anything but epoxy anymore...
09-18-2013 06:01 PM
69 widetrack X2 on jcclark's comments, all I use now is can't go wrong.

09-18-2013 05:52 PM
65 f-100 restore
epoxy primer will stick to Air

I have been using Epoxy primer on my 65 f-100, and it sticks to everything, I have been taking all the paint down to bare metal and bringing it up with Summit Racing K2 epoxy primer, with a Northern #19418 primer spray gun with a 1.8 tip. I am 66 yrs old and I have learned by listening and by error.
Sand smooth with enough scratches for the epoxy primer to stick,then lay on two coats of primer.
01-03-2006 11:44 AM
jcclark Yes, epoxy primer will adhere fine to all those and you can block it
after it cures to level out the surface even better.
You can't go wrong with epoxy primer.
2k primer is not intended for bare steel, it sands and levels better than epoxy
and some painters will put 2k over epoxy just for sanding/leveling.
But really, epoxy primer will usually be enough by itself and it also does a
better job of sealing.
01-03-2006 10:10 AM
epoxy/2k over sanded BC/CC

I am currently working/learning on a 1992 ford mustang. I have recently blocked the fenders out by hand sanding the factory BC/CC. when doing this you sometimes have lets say a feathered area that you can see all of the layers clear/base/primer/steel. My question is as long as the correct grit sandpaper is used and wiped down sufficiently, does the epoxy/2k hi build stick correctly too the different layers w/ out taking everything to steel.
I hope this makes sense.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 07:00 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.