|09-19-2018 07:15 PM|
I do happen to have an Hunter 800 operations manual but sadly that is all for the 800. As I have recommended before, I will send you a 700 service manual since they may be closely related just vertical instead of horizontally oriented. PM me your email if you are interested in either or both. I tried to send you a PM but was not able, perhaps because of your single post count.
|09-19-2018 09:27 AM|
|CZilla||I know this is an oldie and most people seem to have the 700 series on hotrodders, but if there is someone with the 800 series service manual, please message me, it would be greatly appreciated.|
|04-30-2017 05:13 PM|
|04-28-2017 02:34 PM|
|Shayne354||I'm hoping this isn't a dead thread. I'm in need of the Hunter 700 manual. I've tried messaging members that have it but for some reason the system won't let me send messages. My email is [email protected]|
|04-27-2017 04:49 PM|
|Shayne354||Any chance you could send me the manual too? Just got a Hunter 700 and need to get it up and running|
|12-23-2014 04:08 PM|
I do have the manuals. Send me your email and I will send it over. I also did not have any sucesss with my diagnostics. I cannot get a hold of the calibration weight. Anyone know where I could find one?
|12-01-2014 07:47 AM|
|Longshot357||I didnt have any luck resolving the issue i had with the 700 manual. Were you able to get a hold of one for the 800 model?|
|11-06-2014 06:01 AM|
|Jspec||If anyone still needs the manual for the hunter system 800 balancer just let me know and I will email it to you|
|11-03-2014 03:10 PM|
800s seem to be rare compared to 700s
Like I did for the OP, I will send you the model 700 manuals and you can try to make sense of it. Try contacting the OP and see what he came up with.
Please reply in this thread to let me know if the circuit boards and vibration transducers are the same or similar as pictured and described in the 700 manuals.
|11-03-2014 01:26 PM|
|Jspec||Or if anyone can email any documents they have to [email protected]|
|11-03-2014 09:04 AM|
Good morning. I know this is an old thread but I was also looking to score some manuals and calibrating instructions for my hunter systems 800 wheel balancer. I works and spins fine but once I put the weight on and spin for the final time the numbers are out to lunch. If anyone has any information on this it would be highly appreciated.
|03-17-2014 04:30 PM|
3 PDF documents sent.
|03-17-2014 01:39 PM|
|03-17-2014 10:02 AM|
The guy i had purchased mine from i assume must have been a dealer or worked for one at some point in time as he was pretty well educated on the brand. He
Told that hunter purchased these units from schenck amd rebranded them for u.s. sale. I posted in that section. Once i can get a manual ill let you know how i make out.
|03-17-2014 07:45 AM|
The layout of the controls look a lot like my Hunter System 700. I noticed the circuit boards in my 700 have "made in W. Germany" on them.
If you run into a dead end on 800 info, try researching the 700. Here is a link to some of the discussions elsewhere.
|This thread has more than 15 replies. Click here to review the whole thread.|