Hot Rod Forum : Hotrodders Bulletin Board - Reply to Topic -- Hot Rod Forum

Register FAQ Search Today's Posts Unanswered Posts Auto Escrow Insurance Auto Loans Advertise
Hot Rod Forum : Hotrodders Bulletin Board > Tech Help> Hotrodding Basics> 383 stroker
User Name
lost password?   |   register now

Thread: 383 stroker Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :

Register Now

In order to be able to post messages on the Hot Rod Forum : Hotrodders Bulletin Board forums, you must first register.
Please enter your desired user name (usually not your first and last name), your email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:
Please select your insurance company (Optional)


Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-03-2019 06:21 AM
ericnova72 From the same source RWENUTS posted above, under "Tech tips"
How to adjust the mixture screws on your carb

4 corner idle carb, all mixture screws should be roughly equal, and within 1/8 turn of each other.
You'll probably end up somewhere near 5/8 to 1 full turn out.
The 1-1/2 turns out setting you see posted a lot is just to get a new or rebuilt carb up and running on the engine, so that you can then adjust it to fit with the engine.
It will almost always be way rich at that factory setting.
06-03-2019 06:03 AM
Mjusza Hey thanks a lot for that write up.

Now I’m having an issue with it running really rich. What type of carb settings do I start with and how do I go about fine tuning. Currently running a 700 Brawler carb. I have the front screws backed out 1 1/2 turns from seated position and the rear screws the same, I was told that the rear only need to be backed out a half a turn as that’s not the primary side and it do t need to be the same as the fronts. Can someone please help me out. Thanks guys!
06-02-2019 06:22 AM
RWENUTS We all could ‘splain it but I’ll just post this link.

Where should I set the timing on my performance engine?
06-02-2019 12:32 AM
383 stroker

Hey guys I’m working with a 1970 chevelle with a 383 stroker crate engine. I really need help with setting the timing of this engine, I have a snap on dial type timing light. How do I set the initial timing and at what rpm do I set it and also the total curved timing. I was told that I can’t go over 33 degree total ting on this engine. My issue is that I seem to be all over the place. I need to know at what rpm I should be to adjust the initial and total. I’m new to this and would really appreciate the professionalism from you all. Thanks in advance

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 06:53 AM.

Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0 PL2
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright 1999 - 2012. All Rights Reserved.