Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - PPG epoxy failing
View Single Post
  #15 (permalink)  
Old 06-22-2016, 04:56 AM
deadbodyman's Avatar
deadbodyman deadbodyman is offline
Registered User
 
Last wiki edit: Stripping paint
Join Date: Feb 2009
Location: augusta,ga.
Age: 59
Posts: 7,950
Wiki Edits: 11

Thanks: 104
Thanked 1,463 Times in 1,115 Posts
Quote:
Originally Posted by Rustyfender View Post
It doesn't seem to matter 110 grit dry 180 grit as of lately sand blasted on a set of rims, PPG rep out Monday would not address blame just that they would take care of it. wanting me to swap to wash prime DPS3055 and DAS3027 the prime alone list over 400 with hardener Prices are getting out of hand.
The prices these guys want infuriate me especially when they don't preform well. That's the main reason I do what I can to inform everyone that theres a better product out there and at a cheaper price. One of the things I love about SPI epoxy is the cost, at around 150- 200 for the primer and hardener (2 gallons) its a good deal and its top shelf stuff. Id call SPI and see who sells it near you or order some if you have to. You wont regret switching, you'll actually feel good about it. Its a good feeling knowing you can stick some 2" tape anywhere you want and yank it off without pulling of all the paint and primer with it.
Reply With Quote
The Following User Says Thank You to deadbodyman For This Useful Post:
Rustyfender (06-22-2016)