Hot Rod Forum : Hotrodders Bulletin Board - View Single Post - Trunk lip and roll pan matching
View Single Post
  #13 (permalink)  
Old 05-24-2019, 11:31 PM
idrivejunk's Avatar
idrivejunk idrivejunk is offline
Grand Prix User

Last journal entry: Last look
Join Date: Dec 2015
Location: NW AR, USA
Age: 53
Posts: 4,280
Wiki Edits: 0

Thanks: 4,875
Thanked 5,855 Times in 3,408 Posts

I just wasn't picking up what you were laying down. Said it a hundred times... I usually do the right thing, given enough time.

This do anything for ya? I get splitting the lid now, and the head injury thing too. And chair. Look-

I split it up at the body side molding height and made iffy suggestions.

The pocket from my driver was first to come to mind. You could cut it out of the plastic bumper and trim it to fit over a big hole in the lower lid. I sized it up about like this to kinda see how big. Looks like it works out. Top pic is more of a guess. Plenty of those in the junkyard.

If it grabs you right or you want a change, say so. You asked so gently I didn't realize that a simple edited pic might help you out. But there ya go.
Reply With Quote