Well as said in the last post onto the tray once again.
I had a few mishaps when I was buffing the tray, they say it was tied hands, I dropped the angle buffer and this ended up cutting through the clear-coat and the base coat. After discussing what can be done everyone said sand it back with 600 wet and dry and start again. After a few very hot and cold days the steel under the bond-fill cracked away. I have purchased a new product of bondi this has fiberglass mixed in it, hopefully this will solve the problem.
Photo 1 I cut all the filler out and replaced it with fiberglass.
Photo 2 Once again sanded it all back and blended the repair in.
Photo 3, 4 and 5 Shows the chips and rub through marks
