10/18/07
I had to notch out the top of the frame rail in order for the steering box to sit in the proper position. I also had to drill two new holes. One of the holes was already in the right spot. I cut the top of the frame rail off so I could notch it and so I could reinforce it with heavier ¼ inch thick plate. I also tacked in a reinforcing plate on the outer side of the frame that will be welded on later. I also had to heat the inner fender and bump it out about a ¼ of an inch around the box so the box would clear it. The sector shaft and pitman arm sit in exactly the same position as the original.
