Then it was time to put the disk rotors onto the stub axles.
This is where another problem started (I spotted this through last week at work while doing a 'dry fit')
You see I bought the front end without the disk rotors as I already had my own.
I bought new bearings but one would go on the left hand side stub axle, I tried it on the right sit and went on fine so I called Rod at Rod Tech up to ask for advise.
He said he can fix it but I will have to send it back, I asked him if it were an easy fix and he said all that will need doing is to rub it down with some wet and dry for a few Min's so I decided to give it a go myself.
And it worked!
So both sides were fitted with the new disk rotors..
Then the stub axles were fitted to the A-Arms, the tie rid ands connected and then the brake calipers fitted.
I done this on both sides....
And thats it, looks really cool sitting there.
I have lined it up and tacked it into place.
Now its time to start setting up the 4 bar rear end...
