Hot Rod Forum banner
12569598812.jpg

12569598812.jpg

  • 0
  • 0
12569598811.jpg

12569598811.jpg

  • 0
  • 0
12569598810.jpg

12569598810.jpg

  • 0
  • 0

Interior - backer panels - Oct 30, 2009

Photo # 1 - Here is a close up of the offset ½" holes. Note also that after drilling the holes I hit each hole with my air sander to knock off the ragged edges left in the Marlite after drilling. If this isn’t done, the clips will be too tight and very difficult to adjust and position.

Photo # 2 - shows how the clip fits to the panel. You can just make out the original screw hole under the rounded end of the clip. This indicates the prong should be about dead center in the hole in the body.

Photo # 3 - shows the panel flipped over and the prong end of the clip. The tips of the prong are almost directly above the original screw hole.
There are no comments to display.

Album information

Category
Photo Journal
Album owner
Cboy-Two
Date created
Item count
3
View count
36
Comment count
0
Rating
0.00 star(s) 0 ratings

Album privacy

Cboy-Two

Can view media items
Everyone
Can add media items
Album owner only

Share this album

Top