I'm getting near the fabrication finish on the right rear fender. I put in another 4 hours to day. I will still have to weld in the pie cuts later and some hammer knocking from the inside of the wheel well when I take the tire off. But not right now I went to the other side of the car to play catch up on the fenders. In the photo you will see I have 4X4 ft piece of sheet steel all clamped on and marked for cutting. I'm eager to see how close I can match this fender. Hmm glad you cant' see both sides all at the same time. he he eh In the photo you will see where I welded in one pie cut patch from scraps. Just wanted to see what it was going to look like and if it will be below the surface, and it was. I have a few photos..