Back to work on the e-brake cables. The right side was the tough one due to the need to cross over to the left side of the car, keeping clear of the driveshaft.
A spot was finally selected far to the left which allowed for more gentle curves in the cable housing. The mount needed to be 1 inch lower than the floor due to the floor brace just to the rear of the location. The mount was held in place temporarily until it was certain the cable would fit and function.
The cable was secured with Made 4 You clamps.
The mounting tube had a gusset added to the front of it. The ends were closed off. Finally the finished mount was attached to the floor pan with 4 rosette welds.
