With the completion of the inner/outer/cowl rebuild complete, I now have the pleasure of working on putting the floors into my Impala. NOW, I feel like I'm actually building a car.
PIC 1: the full passenger side floor pan, looks pretty good sitting on the saw horses...
PIC 2: Reality hits.... the pan fits good along the rocker, rear seat pan (not shown) but doesn't match up well with the tranny tunnel <sigh>
PIC 3: Another shot, closer to where the kick panels would be. The pinchweld seam matches pretty close in the toe board area for about 1/2 the toe board, then the gap starts and maxes out at the top of the tranny tunnel
What to do??
