Hot Rod Forum banner

S10 fabrication (cont'd) - Apr 6, 2013

The windshield wipers are getting close to completion after moving the wiper motor mount 1/2 inch lower. I had to rework the mount points for the pivots as the wiper arm ends were past the horizontal center line of the windshield. I fabricated a couple of brackets from sheet metal, flanged the edges with a hammer and dolly, and curved them a bit with the shrinker. Now, 12 inch wiper arms place the wiper blades properly on the glass. The driver's arm has too much travel, so I'll rework the connection rod's mount points on the center pivot.
There are no comments to display.

Album information

Category
Photo Journal
Album owner
Supercharged03
Date created
Item count
5
View count
50
Comment count
0
Rating
0.00 star(s) 0 ratings

Album privacy

Supercharged03

Can view media items
Everyone
Can add media items
Album owner only

Share this album

Top