Hot Rod Forum banner

S10 fabrication (cont'd) - Jan 25, 2012

Once I had the rear corners rounded out and leveled, I crossed two adjustable braces on the inside of the rear and pulled each corner in. The rear end is now about eight inches narrower than the grill area was. This required cutting a piece from the hood to fashion the rear deck. My son cut a piece of 1/8" plate to match the new curve of the narrowed deck and I used it to frame the skin of the tailgate and create the rear panel.
There are no comments to display.

Album information

Category
Photo Journal
Album owner
Supercharged03
Date created
Item count
5
View count
51
Comment count
0
Rating
0.00 star(s) 0 ratings

Album privacy

Supercharged03

Can view media items
Everyone
Can add media items
Album owner only

Share this album

Top