Hot Rod Forum banner
Cancel
Sunrise at the workshop
Trunk sides are old wooden wagon wheel rim cut in half and hammered to fit profile of lid. Kinda neat using 100 year old wheel.
Seats are made from table base bottoms I found at town dump
Cowl sides are re-purposed 4 door skins.
Sunrise at the workshop
Built a rolling cart for my roadster body
Fitting rear wheelwells is a bit tricky as jeep frame is a foot or so too short, but room enough for 21" doors which should look ok.
My workshop with beginnings of roadster body. I'm going to paint an eight ball on the ratster's doors, as that is my garage's name (Eight Ball Garage)
R

Sunrise at the workshop

Report
Watch Add bookmark
There are no comments to display.

Media information

Album
31 Ratster build
Added by
RATSTER31
Date added
View count
22
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Top