Hot Rod Forum banner

aluminum

  1. Aluminum Anodizing

    Body - Exterior
    I'm in the process of repairing all the dents and scratches in my aluminum trim and re-polishing it. Of course this means removing the anodizing in those areas. I'm considering using something like oven cleaner to remove all the anodizing on the parts. I've got a couple of questions on...
  2. Aluminum elbow radiator filler necks?

    General Rodding Tech
    Does anyone know a company that makes aluminum elbow radiator filler necks? I have a new aluminum radiator I just need to relocate the neck! (see photo) KK [email protected]
  3. Help Me Identify This Shiefer Flywheel

    Engine
    I recently purchased a fixer-upper of a house. While cleaning out the attic I ran across an old cardboard box stuffed between two studs. Inside was an aluminum Schiefer Flywheel and all original manufacturer paperwork. Flywheel is marked: Schiefer, ALCOA, PAT 2719438, 30065 148, 30-30065. US...
  4. Need ya'lls opinions on SBC heads

    Engine
    Hello fellow hot rodders, I built a .030 over 350 flat top motor instead of the 327 for my '68 Impala. The motor hasn't been decked or anything just the overbore. I put my "186" camel hump heads on it that have been cut 0.010, previous owner ported to the max, on the runners anyway, 2.02/1.60...
  5. high temp enamel paint on aluminum?

    Transmission - Rearend
    Does enamel paint (on the outside of course) raise the internal temp of a transmission? Or are there any other reasons that his would be bad?
Top