Hot Rod Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 7 Results
  1. Engine
    First of all I want to apologize for my ignorance. I always wanted to have a carb motor but I have limited knowlae about them so I bought this 1987 Chevy with a recently rebuild motor and manual tranny. It was working fine until it didn’t after a few hundred miles it works perfectly fine...
  2. Hotrodding Basics
    this might be lengthy but im aggravated and want to explain. I have a 1947 chevy truck with a 454 in it. ive had it for about two ywears and it was completed by someone else, it sat for about 10 years . I bought it. and ran great ! no issues. it was like a daily driver , I drove it all the...
  3. Engine
    i changed my intake and carb to a rpm air gap and 750 holley. now when i floor the pedal it studders. also when im at a stop light you can feel the motor shake and studder. i was thinking it might be that it needs more fuel or timed. any help would be appreciated thanks!
  4. Engine
    My chevy 350 has been driving like its out of gas for the past week. At first it would get up to around 65 mph and start to sputter. Now it wont go faster than 15 mph. When doing some trouble shooting, i disconnected the vaccuum advance from the carburetor and there was no change in rpm at all...
  5. General Rodding Tech
    I have a 383 bored .30 over with a Hydraulic comp cam and aluminum 440 stealth heads with pro comp roller rockers. Stock mechanical fuel pump, double roller timing chain and gears. edelbrock performer intake with quickfuel 600cfm carb. Headers as well. I am running a chrysler electronic...
  6. Engine
    Hi. hope someone is willing to help. I'm having trouble with the idle on my ride. It's a '69 El Camino with a 468 and it has a BDS 8-series blower with two Holly DP's. I live in Ft. Lauderdale and am trying to get the car ready to cruise again. It's too hot to ride in the summer down here...
1-6 of 7 Results