Hot Rod Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Engine
    Hey guys, Ive got a stock chevy 350 and its been running fine until recently it's been stalling and leaking gas. So my issue is that I crank the engine and it starts with no problem then after about 5 seconds of idle, it stalls and turns off. As it is about to turn off my Edelbrock 1406 carb...
  2. Engine
    Okay. Online I can find all sorts of videos to tune a Holley carb with the top adjustment screws. My Holley 650 Classic does not have those screws on top of the bowls. I have gas leaking out both sides the throttle shaft of a recently rebuilt carb. It only leaks after driving a few blocks. Does...
  3. Engine
    A little help here...please! I'm 2 months in and new to all this. I have an SBC bored .040 over with a dual quad set up running (2) 4160 carbs and a tunnel ram intake. The truck is a '53 Chevy swap to a '99 s-10. I am still running the stock pump with a Holley 12-877 fuel regulator. What...
  4. Engine
    Alright so as some of you guys may know by now, I am plotting out a budget 454 twin turbo build. Now, I have decided on all the parts I need, minus heads, but that can wait for another discussion. What I need help on right now is the carburetor. I have basically boiled it down to two options...
  5. Hotrodding Basics
    Im looking to run a 650 edelbrock but having a hell of a time finding one at a decent used price. So, in the meantime, **********.......... is it possible to change some rods, jets and springs to get a 750 to run like a 650 or a 600 to run like a 650??????? Im more less referring to...
  6. Engine
    I have a 352 with fuel problems. If I gravity feed the engine it runs fine, but I am not getting fuel from the pump to the carb. the mechanical pump is new with new fuel line to the sending unit. the sending unit is new as well. i have had this problem with the stock carb so i installed a holley...
  7. Hotrodding Basics
    i hav e a650 cfm edelbrock carb i cant ever get it to stop leaning out no matter how much i set the needel valves what do i do its always to lean and i can smell it ive tried timing ive tried different neddels i have tried everything i can think of besides fuel
1-7 of 7 Results
Top