Hot Rod Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Transmission - Rearend
    Im swapping out the old 305 in my elCamino with a 383 and im keeping the trans that came in it (2004r) i was wondering if the bigger block will change the drive shaft length or if the stock one on the car will still fit, either way i want to swap it out for an aluminum one at some point and im...
  2. Transmission - Rearend
    I've read that the idea situation would be to have the angle of the trans output shaft and pinion shaft should be equal and offsetting - that is, whatever angle the trans is pointed down then the pinion should be pointed up the same amount. My question is, how much difference in allowable...
  3. Transmission - Rearend
    I've read that the idea situation would be to have the angle of the trans output shaft and pinion shaft should be equal and offsetting - that is, whatever angle the trans is pointed down then the pinion should be pointed up the same amount. My question is, how much difference in allowable...
  4. Transmission - Rearend
    I've read that the idea situation would be to have the angle of the trans output shaft and pinion shaft should be equal and offsetting - that is, whatever angle the trans is pointed down then the pinion should be pointed up the same amount. My question is, how much difference in allowable...
  5. Transmission - Rearend
    I need a drive shaft for my 1932 Hot Rod project. I measured from center of my yoke on my engine/transmission end to center of yoke on my rear end. It is 33 3/4" inches. I can buy a drive shaft that is 33" long from center yoke to center yoke from Speedway motors. Would there be a problem if I...
  6. Transmission - Rearend
    I have a vehicle with a 350 Chevy transmission... Can I use AVY rear end with that trans? Will I have to do anything to the drive shaft or are they universal? Thank you.:confused:
1-6 of 6 Results
Top