Hot Rod Forum banner

engine mounts

  1. Raised SBC Engine Mounts

    Hotrodding Basics
    Hi Guys, Anyone know where I can get some raised engine mounts for a 1986 SBC, 350/5.7. 3 Hole bolt pattern to the block. I need to raise the engine about 2 inches higher than what the standard pedalstyle mounts allow due to blower pulley clearance.

  2. Big Block into '68 Impala - Advice Needed

    Engine
    I am putting a Big Block into a 68 Impala, and need some advice on engine mounts/frame brackets. It has Hooker headers, sized for a 502 which is the engine in the final plan. Right now it has a 454 from a truck with a 4L80E trans. The issue is primarily that the headers don't clear the...

  3. Engine Mounts for engine swap

    Engine
    Hello! I recently picked up a 72 nova with a 250 6 cylinder engine and am planning to do a 383 stroker swap. Does anyone have any suggestions or opinions on what type of engine mounts that I should use. Anyone had any bad or good luck with any particular brands? Any help would be greatly...
Top