Hot Rod Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Fuel injection Engines
    Hi, I’ve got a 1969 Camaro with a 389 stroker that I installed the FAST “carb replacement” system on. New gas tank with pump, new manifold, the works, new 1/2 fuel lines, and I refreshed the internals with Total Seal rings, new bearings, Lunati Bootlegger cam and kit. Fuel pressure is spot on...
  2. Engine
    I currently have a 1969 010 block 350 2 bolt main, I have had it bored .30, standard pistons, custom delta cam ( not sure of specs ill check) stock sbc crank, eldbrock rpm air gap intake manifold, holly 650 street avenger carb, stock ignition, holly red fuel pump, vortec heads casting # 062...
  3. Transmission - Rearend
    I'm sure this has been addressed on here before, but I searched and came up empty. I've managed to get hold of a "95" 4L80-E out of a GMC 3500 TWD Van that I'd like to install in the "71" Camaro I'm building. Right now the 454 has a Edelbrock carburetor but I'm intending to replace that with an...
  4. Hotrodding Basics
    So the other day I picked up a locked up 69 350 sbc for 35 bucks. I pulled everything out and the cylinders have just a little rust, haven't been previously bored or anything, but i think it's a good block to make a sweet build with. Of course ill have it cleaned up at the machine shop...
  5. Hotrodding Basics
    I don't know hardly anything about nitrous but I'm interested in finding out ****. Suppose I wanted to put nitrous on my 1993, Chevrolet S10, standard transmission, v6 2.8 liter. What would I need to put a nitrous system on it?
1-5 of 5 Results