Hot Rod Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 7 Results
  1. Body - Exterior
    WE are the owners of Oze Rods Shop. WE can make 37 and 40 fiberglass bodies and frames. Check out the webpage for info **** We also carry a windshield for most Wildrod bodies. Jimmy Davis
  2. Body - Exterior
    So, I'm new to the forum and I admit that the vehicle in question is definitely not a hot rod but as I've been researching, this seems to be a great place for getting feedback on bodywork from folks that seem to have a lot of experience. I have a 1990 Mitsu Montero 2 door that I am trying to...
  3. Interior
    I have some plastic kick panels that are deteriorating from age. I was going to make replacements from fiberglass then wrap them in vinyl. I would use a heat gun to stretch and contour the vinyl to panel. My questions are: Do I need to paint the panels before the vinyl wrap? Like an epoxy to...
  4. Hotrodders' Lounge
    Morning all. Been thinking about this for a while, and finally decided to do it. The Bocar, for those who don't know, is a rare sportscar produced between 1958 and 1961 in Denver Colorado. Less than thirty have been found since the factory burned over Christmas 1961, and little by little, they...
  5. Hotrodding Basics
    Last night I glassed the seem of the fenders that I just spit and widened. On the first fender I used a moderate amount of hardener thinking that I may need extra time to work. The color of the Bondo brand long hair fiber glass resin did change after adding the bondo and I did mix it real...
1-5 of 7 Results