Hot Rod Forum banner

manifold

  1. General Rodding Tech
    I have a 78 355 I am stuffing in a 88 jeep Comanche and am changing the exhaust over to a old set of ramhorns below. They are the ones with the 2" opening not the corvette ones. Once I throw some studs and a bit of paint on them they should work fine running between 2-4k rpm. I have no idea...
  2. Engine
    Hey everyone, I've been chasing what I thought was a carburetor tune issue for a while now, and I'm beginning to suspect it's something else. The motor tries to die at idle, and I've done just about everything you can think of to the carb to include air bleeds, IFR sizes, float levels, fuel...
  3. Hotrodding Basics
    hi I already did this optimization : http://img.overpic.net/images/9/9/2/x992vvgi1ou904pe8lf5.jpg but There is still a problem and i marked them previously optimization is i removed the wall of the 1-3 canal and 2-4 ... now when installing the carb for 1-2 barrel have a big problem and this...
  4. Engine
    hey im new to the site and also new to this 73 buick 455 engine rebuild i started a while back, but after all the part searching and modifications i had to go thru i am finally ready to set the timing and here her purr, i hope. the last few things i need help with is figuring the last few...
  5. Transmission - Rearend
    I was wondering if some had a picture of where to hook up the the vacuum modulator to the manifold? I replaced the transmission in my 89 suburban with an th 400 and need to hook up the vacuum modulator but not sure where is the best place to hook it up at. a picture would be nice.:) thank you...
  6. STREETMASTER_EDELBROCK

    STREETMASTER_EDELBROCK

  7. 1960_Pontiac_Tripower_Intake

    1960_Pontiac_Tripower_Intake

Top