Hot Rod Forum banner

no start

  1. Fuel injection Engines
    This is FYI - (I can't find the post asking for this help), so generally speaking, for those who don't know (I did not), a common cause of modern engines failing to start (even when it cranks well) is that battery voltage drops below some threshold (say less that 10.5 vdc) when cranking...
  2. Engine
    Last week my 84 corvette would not start. I had a friend come over and verify that it did not jump timing. So I changed the ignition module and the coil. Turned out to be the coil, so I left bot brand new parts in the car. Then I drove it about 100 miles. Ran better than it ever ran. The...
  3. Engine
    1977 sbc rebuilt, engine rotates for about 5-6 seconds and then makes a grinding noise. Starter is brand new. Sounds like its coming from starter area? Engine was never primed and has timing issues. I dont want to keep trying to start it because Im worried about causing damage. Any ideas what...
  4. Engine
    Hey guys, I have an old komatsu forklift with a Nissan 4 cyl propane engine. The sob wont start for nothing. Its got fuel, spark, timing, compression, I cant even get the thing to fire off of a shot of either. The complete ign has been redone, new carb and regulators. Any Ideas
  5. Electrical
    Hi All, For the past few months, I have noticed that if the truck is started and run for a while (driving or just warming it up), shut off, and then started it again, the starter doesn't work immediately. I have to turn the ignition key a few times before it finally engages. Sometimes I will...
Top