Hot Rod Forum banner

pushrod

  1. SBC: Lost a spring and a push-rod

    Engine
    Hi! I'm looking for some advice about my engine. I don't know as much as I would like to about this engine, but here is what I do know: it is a 327 out of either a '69 Camaro, or early-mid 60s El Camino. Currently in a '70 El Camino. Sportsman II heads. Definitely not stock cam, but I don't have...
  2. Bent pushrods and engine issues above 6300 RPM

    Engine
    Hello everyone, the other day I decided to try and spin my new cam up to 6500 RPM as it's advertised to make power that high. When I got to about 6300 RPM it started missing and power flattened out, it sounded/felt like I hit a rev limiter. I thought it was odd so I let off and cruised it back...
  3. Fuel pump pushrod stuck

    General Rodding Tech
    Hello I have a 1990 silverado 1500 I did a tbi to carb swap to and ran it a bit till the intake fuelpump went so I got a mechanical pump with a push rod I oiled the pushrod when putng it in it was a little difficult I had to tap it in and the fuel pump didnt work I pulled it off cranked the...
  4. PUSH_ROD_LENGTH_CHECKING_TOOL_004

    PUSH_ROD_LENGTH_CHECKING_TOOL_004

  5. Power brakes dont feel right...any suggestions?

    Suspension - Brakes - Steering
    Hey guys. Got a 59 chevy truck with the classic performance power brake conversion on the frame (not up on the firewall). My situation is the brakes work great but they always feel too hard, best way to describe it is when I hit the brake pedal the truck slows down but much slower than it...
  6. sbc_prod_guide_slot

    sbc_prod_guide_slot

  7. PUSH_ROD_LENGTH_CHECKING_TOOL_003

    PUSH_ROD_LENGTH_CHECKING_TOOL_003

Top