Hot Rod Forum banner

rearend

  1. 1965 El Camino, which chunk for 9inch?

    Transmission - Rearend
    Hello, My cars currently situated with a one tire fire, which just ain't cutting it since i've dropped in a 454 with a few upgrades. The one legger was bearable when I had a 327, I would just throw some sandbags in the bed and I was good to go. Now not so much. With the help of big gear head I...
  2. Gear Oil for a Ford 9" rearend with an unknown gear ratio and year??

    Transmission - Rearend
    My '30 Ford Rat Rod is leaking rearend fluid out of the main seal. After I change the main seal, what kind of gear oil should I use? It is a 9" ford rearend with an unknown gear ratio. Please help!
  3. going to posi

    Transmission - Rearend
    I was just needing to know if I can put a posi in my 82 el camino and use the same axles and then put 3.73's in it with out to much trouble iv been looking for a whole rear end assembly that i could just bolt up but i cannot find anything around here thanks
  4. gears

    Transmission - Rearend
    so i need help i have an 82 el camino and i want to change the rear end gears to 3.42 or 3.73's i need to know what all i need and if i can just get the ring and pinion gears and they will just fit right into the carrier but i need to know what all ill have to replace bearings fluids gaskets and...
  5. Re gearing a chevy 10-bolt

    Transmission - Rearend
    I have a 1979 Camaro it has a 350 engine a i think its a close ratio ( on build sheet its says M22 code) saginaw 4speed and 4.11s with the 14" turbine rims. At 60mph im at about 3500rpm. What would be a good gear ratio so it can haul *** but also a highway driver, or would bigger rims and tires...
Top