Hot Rod Forum banner

rust

  1. Broken Bleeder Screw Which Welder to Tack Washer and Nut to Try to Fix

    Suspension - Brakes - Steering
    Hi all, Snapped off the damn bleeder screw on my truck. Did a 24hr soak and heat and CRC freeze spray then tried a bolt extractor which eventually snapped in the hole. So no I am down to welding a washer and nut to see if I can pull the bleeder out. I have access to a 90amp flux and and a...

  2. Can you rebuild an engine with parts that have been laying out for several years?

    Engine
    Hi Everyone im new to the site but i have one specific question. Can I rebuild a taken apart engine with parts (lifters, heads,rockers, camshaft ETC ETC) that have been sitting in a unheated unsealed building for several years? there is rust on everything, is it still usable? Thanks

  3. 1979 camaro radiator core support

    Body - Exterior
    Cant find the core support for a 1979 Camaro anywhere! They only have after market for 70-73. Would a 70-73 core support work on a 79 camaro?
  4. Right rear panel

    Right rear panel

    Right rear panel needs work.
    • knucknuck
    • Media item
    • Comments: 0
    • Album: knucknuck
    • Category: Member Galleries
  5. Progress shot door

    Progress shot door

    • Airbrushguypdx
    • Media item
    • Comments: 0
    • Album: Airbrushguypdx
    • Category: Member Galleries

  6. 1977 Chevy K20: Body Rust - Assessment and Advice Needed

    Body - Exterior
    Hi All, I have a 1977 Chevy truck that seems to be suffering from rust. The rust appears to range from as minor as surface rust to as much as what appears to be rot in the passenger side of the floor board. The passenger side appears more heavily affected than the driver side. Images are...
Top