Hot Rod Forum banner
sheet metal
1-4 of 4 Results
  1. Body - Exterior
    I need your Help to I D for some old sheet metal parts.. my dad had a 59 El Camino a 67 GTO.. I know He helped work on a car with a rear exposed continental kit - spare tire like what's on a 57 T Bird. The part with the holes I think was fender to fender support on a late 50's -60's car...
  2. Body - Exterior
    I'm attempting to fab the lower 6 inches of the door skin on my '57 F100. I'm running into a "which came first, the chicken or the egg" issue. I've cut the bottom 6" of the door skin off. It was swiss cheese. The picture below shows the first cut, which was 6"x 12". After that cut I found...
  3. Body - Exterior
    Hello everyone, I am working on a 1970 Buick Lesabre and the rear wheel wells on both sides are horrible. The previous owner riveted more metal on top of it, which that rusted as well. I have basic tools for fabricating sheet metal, which means I don't have an English wheel that would make this...
  4. Interior
    Ok so I finally decided to start the whole dash/wiring replacement on my elky. One big problem...the entire passenger side was rusted to ****!!! I'm not talking about the dash pad, I mean the actual dash panel that's made of metal and welded to the body! Worst part is that no one makes these...
1-4 of 4 Results
Top