Snapped off the damn bleeder screw on my truck. Did a 24hr soak and heat and CRC freeze spray then tried a bolt extractor which eventually snapped in the hole.
So no I am down to welding a washer and nut to see if I can pull the bleeder out. I have access to a 90amp flux and and a...
hello all, I am currently about to start boxing the frame rails on my 35 ford chassis, I've removed the X brace and cut the boxing plates (11 gauge)to tuck neatly inside the factory C channel frame. question is,.. if you mig weld the plates in, and then grind them for a "smooth" look, doesnt...
I have an old Honda Trail 70 (not really a hotrod I admit).
I haven't done any welding or bodywork along these lines before (how I ended up here).
So the metal frame is split and cracked, and I'm trying to figure out how to repair it.
I have pictures of the problem here.